PeakTech 2170 Bedienungsanleitung Seite 58

4. "Range" symbol is flashing when setting the range. Press
5. When setting the reference value, press D/Q/ESR (←) key
6. When setting the tolerance, press D/Q/ESR (←)key and
7. After setting the parameters, remove the standard
8. Press SORTING key again to exit the sorting mode.
Note:
In AUTO LCR mode, the SORTING key is not available.
7.10. PC-LINK mode
Press PCLINK key and USB symbol appears on LCD. Connect
the instrument to PC through USB interface, and the measured
data can be recorded, analyzed, processed and printed by PC.
Press PCLINK key again to cancel the data transmission.
Then USB symbol disappears.
Due to the power consumption in data transmission, please
extinguish USB display when there is no need to transmit data.
Downloaded from www.Manualslib.com
D/Q/ESR (←) key to shift the decimal point unit to left and
press SER/PAL (→) key to right. Press ENTER key to
confirm and enter into the reference value setting mode
automatically. At this time, "Range" symbol disappears.
and SER/PAL (→) key to shift the bit to left and right
respectively. Press PCLINK (↑) key and REL% (↓) key to
make the digit +1 or -1. The flashing bit is the current
setting bit. The reference value setting is available from 20
to 1999 counts. Press ENTER key to confirm and enter
into the tolerance setting mode automatically.
SER/PAL (→)key to select tolerance range: ±1% →±2%
→±5% →±10%
tolerance is +1%. Press ENTER key to confirm.
component and insert the component to be measured. If
the impedance measured does not exceed tolerance
range, the primary display will show "PASS", otherwise
show "FAIL". The current measurement result will be
shown on the secondary display.
manuals search engine
→±20% →±80%-20%. The default
-57-