Power Pack; Noise Emission; Dimensions And Weights - Bosch FSA 720 Betriebsanleitung

8.1.5 Oszilloscope measuring functions
Measuring Measurement
functions range
1)
Secondary voltage 5 kV – 50 kV
Primary voltage 20 V – 500 V
Voltage 200 mV – 200 V
5 V – 500 V
AC-coupling 200 mV – 5V
Current 2 A
5 A
10 A
20 A
30 A
Current 50 A
100 A
200 A
1000 A
The test range is, depending on the zero line, positive or negative.
1)
The measuring range is greater than the permissible measurement
2)
voltage
8.1.6 Oszilloscope functions and specifications
Function
Input coupling CH1/CH2
Input impedance CH1/CH2
(relativ to ground)
Input impedance CH1/CH2
(galvanically insulated)
Input impedance CH2
(differentiell)
Bandwidth CH1
(galvanically insulated)
Bandwidth CH1 (relativ to ground)
Bandwidth CH2 (relativ to ground)
Bandwidth Measurement lead with
voltage divider
Bandwidth CH2
(differential measurement)
Bandwidth 1000 A current clamp
Bandwidth 30 A current clamp
Bandwidth Secoundary sensor
Bandwidth
Primary connecting cable (UNI 4)
Time ranges (relative to 500 scan-
ning points)
Time ranges (relative to 1 scanning
point)
Time basis accuracy
Vertical accuracy
Device without sensors
Vertical resolution
Robert Bosch GmbH
Sensors
Secondary sensor
2)
Primary connecting ca-
2)
ble (UNI 4)
Multi measuring cable
2)
CH1 / CH2
Measurement lead with
2)
voltage divider
Connecting cable
B+/B–
Current clamp 30 A
Current clamp 1000 A
Specification
AC/DC
1 MOhm
1 MOhm (5 – 200 V)
10 MOhm (200 mV – 2 V)
4 MOhm
> 5 kHz = 200 mV – 2 V
> 25 kHz = 5 V – 200 V
> 1 MHz = 200 mV – 2 V
> 5 MHz = 5 V – 200 V
> 1 MHz = 200 mV – 2 V
> 5 MHz = 5 V – 200 V
> 500 kHz
> 30 kHZ
> 1 kHz
> 50 kHz
> 1 MHz
> 100 kHz (20 V)
> 1 MHz (50 V – 500 V)
10 µs – 100 s
20 ns – 200 ms
0,01 %
±2 % of reading
±0,3 % of measuring range
(Offset error for ranges >
1 V) or ±5 mV
(Offset error for
ranges 200 mV – 1 V)
10 bit
Technical data | FSA 720 | 27
Function
Memory depth
Scan rate per channel
8.2 Signal generator
Function Specification
Amplitude -10 V – 12 V
(Load < 10 mA) to ground
Signal shapes DC, sinus, triangle, square
Frequency range 1 Hz – 1 kHz
Output current max. 75 mA
Impedance approx. 60 Ohm
Symmetry 10 % – 90 % (triangle, square)
Curve generation Output rate up to 100000 values/s,
Resolution 8 bit,
Y-full range adjustable ( bit),
Unipolar / bipolar mode
Short-circuit resistance < 50 V static
to interference voltage
Short-circuit resistance < 500 V / 1 ms dynamic
to interference voltage
R
Automatically switched filter and damping elements
for improvement of signal quality.
R
Automatic cutoff for short circuit, interference volt-
age detection at start of signal generator.
8.3

Power pack

Function
Input voltage
Input frequency
Output voltage
Operating temperature
8.4

Noise emission

< 70 dB(A)
8.5

Dimensions and weights

Function
Dimensions H x W x D:
Weight
en
Specification
1 Mega scan values or 50
curves
50 Ms/s
Specification
90 VAC – 264 VAC
47 Hz – 63 Hz
15 V
0 °C – 40 °C
Specification
180 x 550 x 200 mm
8 kg
|
1 689 979 894 2014-08-28