Sampling System; Memory/Ram; User Interface; Power Specifications - Bosch FSA 450 Bedienungsanleitung

34 | EN
...10. Hardware
10.2.5 Oscilloscope
• 4 Banana Jacks – Input channels
• 1 Banana Jack – Ground
• 1 MΩ input impedance all ranges except
the lowest voltage input range (+ 1V) for
channels 1 and 2, which have a 10 MΩ
input impedance to support oxygen sensor
measurements
• 6 Mega Sample/Second (Glitch Capture)
2-Channel mode
• Channels 1
Coupling
• Channels 3 and 4: DC/Ground Coupling
• 4 Independent
converters, 12-bit, bipolar
• Maximum and Minimum Peak detect
• 2 channels of timing measurement (used
for frequency, duty cycle, pulse width)
10.2.6 DVOM
• 2 Banana Jacks – Inputs
• 10 MΩ input impedance
• Electrically
measurement
• Diode testing capability
• Dedicated 68HC11 microprocessor

10.3 Sampling system

• 4 12-Bit Analog-to-Digital
(ADCs)

10.4 Memory/RAM

10.4.1 PCMCIA
• Standard 68 pin Type II Card
• Supports 64 MB Card
• 3.3 Volt
10.4.2 32 MB SDRAM
10.4.3 16 MB flash
1 689 979 945 (28.07.2006)
and 2: AC/DC/Ground
High Speed
isolated for accurate
Converters

10.5 User interface

10.5.1 LCD color display
• TFT color display
• 640 X 480 Color LCD
• CCFL backlight
• Active Area = 162.2mm Horizontal x
121.7mm Vertical
10.5.2 Keypad
• 11 Button key pad
• Software configurable keys
A/D
10.5.3 Touch screen
• Film on glass construction

10.6 Power specifications

10.6.1 External AC/DC converter power supply
• Input Voltage:100 to 240 AC Volts
• Input Frequency: 50 to 60 Hz
10.6.2 Engine Analyzer input power
• 9-16 volts nominal; 28 volts max
• 12.0 volts @ 1A, 2.5A max
10.6.3 Remote power source
• 7.2 Volt
• Nickel Metal Hydride
• Removable
accessible
FSA 450
Battery Pack, Externally
Robert Bosch GmbH