Service And Maintenance - RAIS/attika NEXO 100 GAS Installationsanleitung

Service and maintenance

Learn how to service your gas fireplace in this section. The fireplace must be inspected by an authorised
gas installation technician in accordance with national legislation. The inspection must ensure that the
fireplace functions correctly and is safe to use.
NB! Under no circumstances may you open your gas fireplace front cover – this may only be
done by an unauthorised heating and plumbing and gas installation technician.
Service procedure
Switch off the fireplace and shut off the gas supply. Make sure the fireplace is completely cold before
you begin. RAIS/ATTIKA cannot be held liable for injuries that result from touching a hot fireplace.
Service procedure proposal:
1. Protect the floor by laying out a blanket or other covering.
2. Remove the glass and carefully remove the ceramic logs and embers layer.
3. Use a vacuum cleaner to clean the burner and the perforated plate.
4. Raise and remove the secondary burner. Remove the perforated plate.
5. Vacuum clean the entire burner.
6. Clean the pilot burner assembly using a soft brush and a vacuum cleaner. Do not bend or straighten
the thermocouple.
7. Switch on the gas supply and check for leaks. Check the burners and pilot unit to ensure that they
are in good working condition.
8. Re-fit the perforated plate.
9. Put back the embers layer and ceramic logs.
10. Check the flue gas system and the flue terminal and ensure that they are not blocked.
11. Fit the glass.
12. Switch on the fireplace and check the pressure setting.
13. Ensure that the fireplace is safe to use.
14. Check that the gaskets are in good condition.
15. Worn out parts should be replaced with new parts.
16. Old "logs" and old "embers layers" can be placed in a plastic bag and disposed of with household
waste.
SERVICE AND MAINTENANCE
GB - 57