Remote Control And Receiver; Insertion Of Batteries In The Remote Control; Synchronisation Of The Remote Control And Receiver - RAIS/attika NEXO 100 GAS Installationsanleitung

Remote control and receiver

The following electronic parts accompany this gas fireplace:
Receiver
Remote control
In this section you can learn how to set up the remote control for the gas fireplace. See the separate
user manual for how to use the remote control.
INSERTING BATTERIES IN THE REMOTE CONTROL
The remote control uses 2 x AAA 1.5 V batteries.
When using the fireplace for the first time in the year, you should
replace the batteries.
Replace all of the batteries at the same time. Use only good quality
alkaline batteries.
Never use pointed tools to remove the batteries from the box.

Synchronisation of the remote control and receiver

You must first synchronise the remote control and fireplace receiver in order for the remote control to
function. Procedure to synchronise the remote control and receiver:
Press and hold in the receiver "reset" button
until you hear short 'beep' followed by a long 'beep'.
Release the button.
You now have 11 seconds to press the arrow down
button on the remote control. Hold the button in until you hear a short "beep" from the receiver. You
will know see the world "conn" on the remote control.
The receiver and remote control are now synchronised.
50 - GB
REMOTE CONTROL AND RECEIVER
Remote control