Selecting The Edid Mode Of The Kvm Extender - G&D DL-DVI-Vision-IP-Fiber-Serie Installation Und Bedienung

Configuration
How to select whether and on which module the image display is activated after
restarting the extender:
1. In the menu, click on
2. Click on the computer module (CPU) you want to configure and then click 
on
Configuration
3. Click on the tab
4. Click on the tab
5. Select one of the options given under
None  After restarting the extender, the image display of both modules is
switched off (default).
CPU  After restarting the extender, the image display of console
connected to the computer module is activated.
 After restarting the extender, the image display of the console
CON
connected to the console module is activated.
6. Click on
Save

Selecting the EDID mode of the KVM extender

EDID information (Extended Display Identification Data) of a monitor informs the gra-
phics card of a connected computer about different technical device features. The
information is usually transmitted via Enhanced-DDC (Enhanced Display Data Chan-
nel) and without any alteration between KVM extender and computer.
NOTE:
For initial operation and when connecting another monitor, please follow
the activation sequence recommended on page 11.
Special GUD profiles are provided for some resolutions. The names of these profiles
contain information about the preferred resolution that is transmitted to the graphics
card of the computer when using this profile.
As an alternative, you can use the web application
profile of a monitor. The KVM extender then transmits it to the connected com-
puter. Detailed information about this topic is given in the separate manual of the
web application
Config Panel
41 · G&D DL-DVI-Vision-IP-Fiber
KVM extender
.
.
General
.
CPU
.
.
.
Activate console after start
Config Panel
:
to read out the EDID