Adjusting The Operating Mode Of The Rs232 Interface - G&D DL-DVI-Vision-IP-Fiber-Serie Installation Und Bedienung

1. In the menu, click on
2. Click on the computer module (CPU) you want to configure and then click 
on Configuration
3. Click on the tab
4. Click on the tab
station (on the
Click on the tab
station (on the
5. In the field Permanent access mode
 right for exclusive access is granted (default)
Enabled
Disabled  right for exclusive access is denied
6. Click on Save
Related topics:
 Operating the KVM extender exclusively on page 20
 Changing the video mode of consoles on page 38

Adjusting the operating mode of the RS232 interface

In the default setting of the extender, you can connect any RS232-compatible device
to the optional RS232 interface of the console module. The RS232 data stream is
transmitted unchanged to the computer module.
For transmitting RS422 signals, you can use two
adapters converts the RS232 interface of the console module and the computer mod-
ule into RS422 interfaces.
IMPORTANT: If you want to transmit
you also need to change the operating mode of the RS232 interfaces of both the
console and the computer module.
.
KVM extender
.
.
General
if you want to configure the access to the local work-
CPU
CPU module).
if you want to configure the access to the remote work-
CON
CON module).
, select one of the following options:
.
RS422
G&D RS232-422 adapters
signals, in addition to using adapters,
G&D DL-DVI-Vision-IP-Fiber · 36
Configuration
. Each of the