Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Configuring a KVM-over-IP connection of a user
module
You can carry out the required configuration settings directly on the console.
NOTE:
Use the
local hotkey
the network interface of the user module, or use the
+
) to open the remote OSD to configure the network interface of the com-
Ctrl
Num
puter module.
The settings of both hotkeys are shown during the starting process of the user
module (see Starting process on page 11).
Configuring the network interface
How to configure the network interface:
1. Use the remote hotkey
2. Select the entry
Network setup
3. Select the entry
Interfaces
4. Enter the following data under
Operational
mode:
IP address:
Netmask:
5. Press
F2
to save your settings.
Configuring the global network settings
Even in complex networks global network settings ensure that the KVM extender is
available from all partial networks.
How to configure global network settings:
1. Use the remote hotkey
2. Select the entry
Network setup
3. Select the entry
Interfaces
Establishing a KVM-over-IP™ connection for the first time
(default:
Alt
+
Num
+
to open the OSD of user module.
Alt
Num
and press
Enter
and press
Enter
.
Interface A
Press
F8
to select the operational mode of the interface:
Static:
A static IP address is assigned.
DHCP:
IP address is obtained from a DHCP server.
Enter the IP address of the interface.
The operational mode DHCP does not allow making entries.
Enter the netmask of the network.
The operational mode DHCP does not allow making entries.
Alt
+
Num
to open the OSD of the user module.
and press
Enter
and press
.
Enter
) to open the local OSD to configure
remote hotkey
.
:
.
G&D DL-DVI-Vision-IP-Fiber · 16
(default:
Werbung
Kapitel
Inhaltsverzeichnis
