G&D DL-DVI-Vision-IP-Fiber-Serie Installation Und Bedienung Seite 128

Configuration
How to change the setting of the scancode set:
1. Press
Ctrl+Num
2. Select the row
code set of the remote console (at the
Select the row
scancode set of the local console (at the
3. Under Scancode set
2  activates scancode set 2 for PS/2 keyboard inputs
3  activates scancode set 3 for PS/2 keyboard inputs
4. Press F2 to save your settings.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
1. In the menu, click on
2. Click on the computer module (CPU) you want to configure and then click 
on Configuration
3. Click on the tab
4. Click on the tab
station (on the
Click on the tab
workstation (on the
5. In the
Scancode set
ing options:
activates scancode set 2 for PS/2 keyboard inputs
Set 2
activates scancode set 3 for PS/2 keyboard inputs
Set 3
6. Click on Save
7. Turn the KVM extender off and back on again.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
49 · G&D DL-DVI-Vision-IP-Fiber
(default) to open the on-screen display.
Console setup and press
Local console setup
press F8 to select one of the following options:
KVM extender
.
General .
CPU if you want to configure the setting of the local work-
CPU module).
CON if you want to configure the setting of the remote
CON module).
field of the
Configuration
.
Enter if you want to adjust the scan-
module).
CON
and press Enter if you want to adjust the
CPU module).
.
section, select one of the follow-