Adjusting The Operating Mode Of The Rs232 Interface - G&D DP-Vision-IP-Fiber-Serie Installation Und Bedienung

Configuration
1. In the menu, click on
2. Click on the computer module (CPU) you want to configure and then click 
on
Configuration
3. Click on the tab
4. Click on the tab
station (on the
Click on the tab
station (on the
5. In the field
Enabled
Disabled
6. Click on Save
Related topics:
 Operating the KVM extender exclusively on page 23
 Changing the video mode of consoles on page 41

Adjusting the operating mode of the RS232 interface

In the default setting of the extender, you can connect any RS232-compatible device
to the optional RS232 interface of the console module. The RS232 data stream is
transmitted unchanged to the computer module.
For transmitting RS422 signals, you can use two
adapters converts the RS232 interface of the console module and the computer mod-
ule into interfaces.
RS422
IMPORTANT: If you want to transmit
you also need to change the operating mode of the RS232 interfaces of both the
console and the computer module.
39 · G&D DP-Vision-IP-Fiber
KVM extender
.
.
General
CPU if you want to configure the access to the local work-
module).
CPU
if you want to configure the access to the remote work-
CON
module).
CON
Permanent access mode
 right for exclusive access is granted (default)
 right for exclusive access is denied
.
.
, select one of the following options:
G&D RS232-422 adapters
signals, in addition to using adapters,
RS422
. Each of the