Kessel Comfort PLUS Einbau- Und Betriebsanleitung Seite 48

Float switch
If float switches are to be used for level detection, proceed
as follows:
Pull out blind plugs (1).
Insert M16 cable gland and fix with locknut.
Pull through cable and tighten nut.
Connect the cable ends of the float switches to the termi-
nals shown. (see "Fig. 4: Mono float switch (non-ATEX) ",
page 48 + see "Fig. 5: Duo float switch (non-ATEX)",
page 48)
48 / 220
Installation and operating manual
Fig. 4: Mono float switch (non-ATEX)
Fig. 5: Duo float switch (non-ATEX)
010-700_02