Kessel Comfort PLUS Einbau- Und Betriebsanleitung Seite 47

Fig. 3: Connect the Phoenix contact connector
Pressure sensor
If a pressure sensor is to be used to detect the filling level it
has to be connected as follows.
010-700_02
With the help of a spiral cable puller, feed the pressure
hose through the conduit pipe; to do so, fix the end of the
hose with end cap on the spiral cable puller.
Cut off the end of the pressure hose with end cap to fit
precisely.
Push the pressure hose onto the connection nipple of the
pressure pipe connection.
Tighten the clamping nut.
✓ Lay pressure hose continuously rising.
In case of lengths of more than 10 m or reverse gradient
of the pressure hose, use the compressor set for air bub-
bling (art. no. 28048).
Installation and operating manual
47 / 220