Network Interfaces - G&D ControlCenter-Compact Serie Installation Und Bedienung

Network interfaces

NOTE:
configure the central module via Config Panel web application and use the
enhanced network functionalities (for example authentication against directory
services, time sync via NTP server, netfilter or syslog).
IMPORTANT:
cation, or if you enable the signalling of the Dynamic Ports modes, end the connec-
tion to the web application and remove the twisted-pair cable from the network port
at the central module.
Network A:
available as accessory.
Connect the other end of the cable to a network interface of the local network.
Network B:
available as accessory.
Connect the other end of the cable to a network interface of the local network.
Downloaded from www.Manualslib.com
You need to connect the central module to one or two local networks to
If you change the configuration of the Dynamic Ports in the web appli-
Network B 2 4 6
Network A 1 3 5
If required, plug in a category 5e (or better) twisted-pair cable, which is
If required, plug in a category 5e (or better) twisted-pair cable, which is
manuals search engine
Dynamic Ports
8 10 12 14 16
7 9 11 13 15
Installation
18 20 22 26
24
17 19 21 23 25
G&D ControlCenter-Compact · 7
28
27 29