Smartcard; Setting Water Hardness - Nuova Simonelli MicroBar Gebrauchsanweisungen

UK
La temperatura massima impostabile è 130°C (266°F).
Press the RESET key to exit the submenu and go
back to the main menu and to confirm the temperature
programmed.
The ENTER key is disabled.
21. PASSWORD
Press the ENTER key to access the submenu.
This programmes a new password to access
the functions that can be programmed in the
TECHNICIAN MODE.
Enter a combination of 5 keys (from the 8 keys
available on the keyboard) and set the new
required password.
Press the RESET key to quit the submenu and return
to the main menu without confirming the setting.
Press the ENTER key to confirm the setting.
22. SMART CARD
Press the ENTER key to access the submenu.
This sets the SMART CARD reader to ena-
bled.
The function is enabled by setting the param-
eter to YES.
Press the  keys to enable (YES) / deactivate
(NO) the SMART CARD reader.
23. WATER FILTER L
Press the ENTER key to access the submenu.
This allows you to program the number of litres
of water to be delivered for the display of the
message clean water filter.
The arrow keys  increase/decrease the number
of litres of water delivered for the display of the mes-
sage clean water filter.
Press the RESET key to exit the submenu and go
back to the main menu and to confirm the number of
litres programmed.
The ENTER key is disabled.
24. DE-SCALING
(Microbar version with Tank only)
Press the ENTER key to access the submenu.
The first message to appear concerns the pos-
sibility to set water hardness:
Downloaded from www.Manualslib.com manuals search engine
Using the  key, it is possible to access the actual
de-scaling cycle.
The  keys can be used to select one of the fol-
lowing two functions:
The ENTER key is used to start the selected func-
tion.
The RESET key is used to go back to a previous
menu level.

24.1 SETTING WATER HARDNESS

It is possible to set water hardness according to
French degrees and therefore, an alarm for perform-
ance of the de-scaling cycle.
• When the machine displays this message:
Press the ENTER key to enter the function.
The display will then read as follows:
Use the  keys to set (increase/reduce) the water
hardness parameter.
Press the ENTER key to return to the main menu and
save the setting to memory.
Press the RESET key to return to the main menu
without saving the setting to memory.
The following table shows the correspondence
between the hardness setting and the number of
litres of water consumed after which the "DE-SCALE"
message appears.
Water Hardness °Fr
1-7
8-30
31
00
NOTE:
The "DE-SCALE" alarm will not interrupt machine
operation and it will be reset as soon as the de-
Water litres (gal)
1500
1000
500
Alarm disabled
57