Control Board - EuroLite LED TMH-S200 Bedienungsanleitung

Control Board

The Control Board offers several features: you can easily set the starting address, run the pre-programmed
program or make a reset.
Press OK until the display is lit. Browse through the mode menu by pressing the arrow buttons (up and
down). Press OK 2 x in order to select the desired menu. Browse through the main menu by pressing the
arrow buttons up and down. Press OK to enter the respective menu item of the main menu. You can change
the selection by pressing the arrow buttons (left and right). Press OK in order to confirm. You can leave
every mode by pressing the arrow buttons (left and right). The functions provided are described in the
following sections.
Default settings shaded.
Mode menu Main menu
Run mode
DMX address
Channel mode
Invert PAN
Invert TILT
Set
(Setting) PAN-TILT Swap
PAN-TILT Encoder
DMX signal
Delay
Linear color
Load default
Manu
PAN ...
(Manual)
Ver
Reset Cal
Sys
Sensor Monitor
(System)
System errors
DMX monitor
180°
°C
EN
Set
Run Mode
DMX mode
This mode allows the unit to be controlled via every standard DMX controller.
Sound
With this function, you can run the internal program sound-controlled.
Random auto mode
With this function, you can run the random internal program.
Auto mode (Auto 1+2)
With this function, you can run 2 different internal programs.
DMX address setting
With this function, you can adjust the desired DMX address via the Control Board.
Number of DMX channels
With this function, you can display the number of the DMX channels.
Sub menu
DMX/Sound/Random/
Auto 1, Auto 2
001~ 512
17 CH
ON/OFF
ON/OFF
ON/OFF
ON/OFF
Keep/clear
ON/OFF
ON/OFF
OK/Cancel
PAN = XXX ...
29/36
Function
DMX mode / music control / random auto
program / auto program 1 and 2
DMX address setting
Number of DMX channels
Reverse movement
PAN-TILT swap
Automatic PAN/TILT adjustment
Action if no DMX
Dimmer speed (step response)
Switch color change from step to linear color
Restore factory settings
Test function
Software version
Calibration to standard position
Only service function for producer
Error message
Current DMX address of the channels
Display reverse 180 degrees
Inside temperature
Display language select - English/Chinese
00128934, Version 1.0