Connection To The Power Supply System - KKT KOLBE SET6309ED Benutzerhandbuch

Installation

Connection to the power supply system

!
Safety hints
• All electrical work must be carried out by an appropri-
ately qualified and authorised electrician.
The manufacturer is not liable for damage or injury
caused by incorrect installation or grounding.
• Do not make any changes to the power supply.
• Before connecting, check that the voltage indicated on
the rating plate matches to the actual mains voltage.
• The ground wire should be installed so that it is the
last wire to be pulled in the event that the safety relief
device of the mains lead should fail.
• Due to the heat generated during operation, the power
cable must be routed behind the appliance in such a
way that it does not touch the rear side of the oven.
• A separate and suitable fuse, which complies with local
regulations, must protect the circuit.
It must be tested and provide at least 3 mm spacing
around all poles (or around all active [phase] conduc-
tors if required by regulations).
The fuse must be easily accessible to the installer.
Attention!
• Voltage of heating elements 220-240V
• The ground wire must always be connected to
the PE terminal .
Recommended connection
L1
L2
L3
L3 N2
L2 N1
PE
live wire /
L
line conductor
N neutral
PE protected earthing
PE
N1
N2
L1: none
L2: black
L3: red
N1: blue
N2: grey
yellow-green
53