Herunterladen Inhalt Inhalt Diese Seite drucken

Ottobock 50K30 Xeleton Gebrauchsanweisung Seite 14

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
5.2.4 Conversion to CI Version
>
The orthosis is in the as-delivered condition (ACL version).
>
The CI accessory set is at hand.
1) Loosen and remove the screw connection on the lower thigh strap (strap 3) (see fig. 17).
2) Attach the pull loop on the lower thigh strap and the additional pull loop (see fig. 1, item D; CI
accessory kit) with the longer screw (see fig. 18).
3) Mount the additional strap (strap 6, CI accessory kit) as the front thigh strap.
4) Position the orthosis correctly (see the section "Applying the ACL Version").
5) Fasten the straps in the specified sequence (see fig. 3, straps 1-6).
5.2.5 Conversion to PCL Version
>
The orthosis is in the as-delivered condition (ACL version).
>
The PCL accessory kit is at hand.
1) Remove the lower thigh strap (strap 3), the rear strap for the lower leg (strap 5), and the
upper front strap for the lower leg (strap 4).
2) Turn the pull loop on the lower thigh strap (see fig. 1, item D) to the front.
3) Use strap 4 without tibia pad with the pad on strap 3 as the front thigh strap.
4) Loosen the screw connection of the upper front strap for the lower leg, and remove the front
pull loop (see fig. 19).
5) Mount the pull loop on the rear strap for the lower leg with the short screw (PCL accessory
kit).
6) Use strap 3 with the pad on strap 5 as the rear strap for the lower leg.
7) Position the orthosis correctly (see the section "Applying the ACL Version").
8) Fasten the straps in the specified sequence (see fig. 4, straps 1-4).
5.2.6 Replacing the Straps and Pads
Straps:
► The straps are equipped with opposing hook-and-loop closures and are easy to replace.
Strap and Frame Pads
► The strap and frame pads are attached with hook-and-loop closures and are easy to replace.
5.2.7 Use of liners and covers
Optional liners and covers are available for the orthosis. A liner is used as a layer between the
orthosis and the skin to protect against skin damage. A cover is pulled over the orthosis, protect­
ing it against damage. This also reduces the risk of injury in sports with the potential for massive
body contact (e.g. collisions).
The following products can be used with the orthosis (the size is specified in the reference num­
ber):
Designation
LINER FOR ACL KNEE ORTHOSIS
LINER FOR ACL KNEE ORTHOSIS
LINER FOR ACL KNEE ORTHOSIS
TEXTILE COVER FOR ACL KNEE ORTHOSIS
TEXTILE COVER FOR ACL KNEE ORTHOSIS
TEXTILE COVER FOR ACL KNEE ORTHOSIS
5.3 Delivery
► Check that the brace fits the leg properly at the time of delivery.
→ The centre of the patella and the centre of the joints are approximately aligned.
14
Article number
29K193=M/L/XL
29K193=XS/S
29K193=XXL/XXXL
29K194=M/L/XL
29K194=XS/S
29K194=XXL/XXXL

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis