Special Evaluation Procedures - Balluff BTS M30E0-UUI-H0001-S04G Betriebsanleitung

BTS M30E0-_ _ _-H0001-S04G
Infrared Temperature Sensor
11
11.2
Averaging or peak value detection can be selected. Only one may be activated at a time.
11.2.1 Averaging (moving average)
Averaging is used to stabilize the temperature value under extreme ambient conditions. When the IR temperature
sensor is used in an EMC intensive area, averaging can suppress strong fluctuations. In each measuring cycle the
sensor uses the configured number of the last measuring results to obtain a calculable measuring result by forming
the moving average.
Setting averaging
OUT
[°C]
1
2
3
1. Turn on averaging with [▲] or [▼] and with [↵].
2. Set the number of measurement values for averaging and confirm with
24
Downloaded from www.Manualslib.com
Configuring the IR Temperature Sensor

Special Evaluation Procedures

Note
Activating a special procedure may reduce the switching frequency of the sensor.
Output signal without averaging
Output signal with averaging = 32
Output signal with averaging = 16
[↵].
english
manuals search engine
t