Special Evaluation Procedures - Balluff BTS M30E0-UUI-H0001-S04G Betriebsanleitung

BTS M30E0-_ _ _-H0001-S04G
Infrared Temperature Sensor
11
Configuring the IR Temperature Sensor
11.2

Special Evaluation Procedures

Averaging or peak value detection can be selected. Only one may be activated at a time.
Note
Activating a special procedure may reduce the switching frequency of the sensor.
11.2.1 Averaging (moving average)
Averaging is used to stabilize the temperature value under extreme ambient conditions. When the IR temperature
sensor is used in an EMC intensive area, averaging can suppress strong fluctuations. In each measuring cycle the
sensor uses the configured number of the last measuring results to obtain a calculable measuring result by forming
the moving average.
Setting averaging
OUT
[°C]
1 Output signal without averaging
2 Output signal with averaging = 32
3 Output signal with averaging = 16
1. Turn on averaging with [▲] or [▼] and with [↵].
2. Set the number of measurement values for averaging and confirm with
[↵].
24
english
All manuals and user guides at all-guides.com
t