Switching The Table Off; Troubleshooting; Care - Cor Level Montageanleitung

8.5 Switching the table off

GB
Disconnect the mains plug from the socket. The table is now without power and switched off.

9 Troubleshooting

The following table has been developed to assist you in finding and rectifying common faults. If
a fault should occur which is not listed in the table, please contact COR Sitzmöbel Helmut Lübke
GmbH & Co. KG. These faults may only be examined and rectified by a specialist.
Problem
Table no longer moves
Table only moves at slow speed

10 Care

For your safety
Ensure that the connectors are accessible in order to shut down the system in an emergency.
Avoid mechanical stress on the connecting cable and the connecting lines. Regular visual checks
of the cables at shorter intervals are necessary, especially after any mechanical stress. If the
power cord or connecting cables are damaged, they must be replaced in order to avoid hazards.
Work on the power cord may only be carried out by qualified personnel.
6 4
After disconnecting the mains plug of the table, you should not reconnect it for at
least 60 seconds.
Lösung
- Check that mains cable is plugged in
- Check all plug connections, unplug if
necessary and plug in again
- Check cables for damage, crushing or cable
breakage
- Is the light in the control panel on?
- The table must be levelled again
(see Chap-ter 6.1)