Herunterladen Inhalt Inhalt Diese Seite drucken

Initial Operation; Levelling The Table; Limiting The Table Height - Cor Level Montageanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

7 Initial operation

The instructions described here are to be seen as minimum recommendations. Depending on the
operating conditions, additions may be necessary to maintain the quality of the table.
For repair work in special fields (electrical engineering, etc.), only specialists trained in the respec-
tive field may be employed.
Observe the following safety instructions!
Damage to property or consequential damage may be caused to the table by
improper installation. The following applies prior to commissioning:
• Check all screw and plug connections for tightness.
• Close all the covers.
• Check the table for functionality.
• Level the table before initial operation.
Before operating the table for the first time, the following points must be observed:
• Check that the table has been set up in accordance with the above regulations.
• Make sure that moving components can move freely in the spaces required.
• Make sure that the mains plug is plugged in and the power supply is established.
• Check the functionality of the control panel.

7.1 Levelling the table

Level the Level Table before operating for the first time. Move the table to the lowest position.
Release the button on the control panel and press the button down again for approx. 5 seconds.
The table will make a slight jerk. The table is now level. Now you can use the table normally and
move it up and down as you like.

7.2 Limiting the table height

If the desk cannot be operated in its entire travel range (e.g. if a shelf is blocking upward opera-
tion), you can set upper and lower limits for the height of the desk.
Setting the upper limit
1) Set the table to the maximum allowed height.
2) Press the Bluetooth button and the toggle switch up at the same time until the light flashes.
3) Release the Bluetooth button and the toggle switch.
Setting the lower limit
1) Set the table to the minimum allowed height.
2) Press the Bluetooth button and the toggle switch down at the same time until the light flashes.
3) Release the Bluetooth button and the toggle switch.
GB
5 9

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Level elektrisch

Inhaltsverzeichnis