Table Operating Elements; Mains Plug; Transport; Installation - Cor Level Montageanleitung

4.2 Table operating elements

4.2.1 Mains plug

5 Transpor t

5.1 Transport

Warning!
When transporting outdoors, make sure that no water gets onto the individual
components of the system, otherwise short circuits could occur when connecting
the sensors later.
Warning of crushing hazard!
When shipping the table, it must be lifted and transported. The table may tip over
and fall as a result of improper lifting or transportation.
At least two people are required to lift the table.
Wear safety shoes when transporting the table!
Transport using industrial trucks:
If a hand pallet truck or forklift truck is used for loading or unloading, it must be suitable for the
loads and in perfect working order. The centre of gravity of the transported goods must always be
observed!
During transport, the load must be evenly distributed and the components properly secured. Avoid
jerky movements.

5.2 Installation

For the proper and safe installation of the table, it is absolutely necessary that a level installation
surface and sufficient load-bearing capacity are available to ensure the stability of the table.
The table has a control panel on the right side
of the table top. The position of the table can
be moved up and down using the control panel.
The mains plug is used to disconnect the table
from the power supply. The mains plug is loca-
ted on the underside of the table.
GB
5 1