Cor Level Montageanleitung Seite 55

8
9
Assembly of the cable guides
The table is supplied with both a horizontal
cable guide, which is mounted under the
table top, and a vertical cable guide (stocking
sleeve). The horizontal cable guide is intended
for laying cables (e.g. mains cable, telephone
cable, power cable, LAN cable, etc.) under the
table top. This consists of 3 clips incl. 3 screws,
which you can screw on individually according
to your requirements. Place these clips in a
position of your choice below the table top and
fix them in place with the screw.
TIP: Position a clip vertically over a leg end
on which you can later hang the vertical cable
guide.
You can now clip any cables into the cable
guide
The vertical cable guide has a zipper that can
be fully opened or closed. There are elastic
loops at both ends of the stocking sleeve. The
larger loop is attached to the table leg and the
smaller loop to the table top.
Now insert any cables into the cable guide and
close the zipper completely.
GB
5 7