7.12 Setting the reminder interval
GB
1) Press the Bell button to set the interval that reminds you to change position.
2) Switch through the intervals by pressing the Bell button.
If the LED is not lit, the reminder is deactivated.
Using the app, it is possible to adjust the three intervals to user-defined values.
7.13 Resetting the reminder
Press the Bell button for eight seconds to reset the reminders to their default values.
The LED flashes red when the reminder has been reset.
8 Operation
8.1 Operating modes
To operate the table, two possible operating modes are available:
• „Off" operating mode
(machine in sleep mode)
• „Jog" operating mode
(jog mode)
8.1.1 „Off" operating mode
In the „Off" operating mode, the machine is in sleep mode.
8.1.2 „Jog" operating mode
As long as the button on the control panel is pressed, the table moves to the corresponding
position.
6 2
Warning!
• Despite the sleep mode, the machine is not energy-free.
• Switch off the table via the mains plug before starting repair work.
• In addition, dissipate any residual energy or stored energy.
After switching off the table via the mains plug, you should not reconnect the
mains plug for at least 60 seconds.