Status / Alarm Codes - Gtec CPS 6 Handbuch

S /
TATUS ALARM
Using a sophisticated self-diagnostic system, the CPS can check and indicate on the display panel its status and any
errors and/or faults that have occurred during its operation. When a problem arises, the CPS signals the event by
showing the code and corresponding type of alarm on the display.
➢
Status: indicates the current status of the CPS.
CODE
S01
S02
S03
S04
S05
S06
S07
S08
S09
S10
S11
S12
S13
➢
Command: indicates that a command has been activated.
CODE
C01
C02
C03
C04
C05
C06
C07
C08
➢
Warning: messages that refer to a specific configuration or operation of the CPS.
CODE
W01
W02
W03
W04
W05
C
ODES
BOOST stage or battery-charger locked – load not powered
Frequency converter - load powered by inverter
Synchronization disabled (CPS in Free running mode)
DESCRIPTION
Precharging
Load not powered (stand-by status)
Power-on phase
Load powered by bypass line
Load powered by inverter
Battery operation
Waiting for batteries to recharge
Economy mode enabled
Ready for power on
CPS locked – load not powered
CPS locked – load on bypass
DESCRIPTION
Remote power-off command
Remote load on bypass command
Remote power-on command
Battery test running
Manual bypass command
Emergency power-off command
Remote battery charger power-off command
Load on bypass command
DESCRIPTION
Battery low warning
Programmed power-off enabled
Programmed power-off command imminent
Bypass disabled
- 110 -