Buzzer - Gtec CPS 6 Handbuch

B
UZZER
The status and faults of the CPS are signalled by the buzzer, which will emit a sound modulated according to the
operating conditions of the CPS.
The various kinds of sound are described here below:
Sound A: The signal is emitted when the CPS is turned on or off using the relevant buttons. A single beep confirms
power-on, activation of the system test, cancellation of the programmed power-off. When the power-off
button is kept pressed, the buzzer emits the sound A quickly four times, before confirming power-off by
emitting a fifth beep.
Sound B: The signal is emitted when the CPS switches to bypass to compensate for the surge current due to the
activation of a distorting load.
Sound C: The signal is emitted when the CPS switches to battery operation before the battery low signal (sound D).
Possibility of silencing the report (see paragraph "Graphic Display")
Sound D: The signal is emitted during battery operation when the battery low alarm threshold is reached.
Possibility of silencing the report (see paragraph "Graphic Display")
Sound E: This signal is emitted in the presence of an alarm or lock.
Sound F: This signal is emitted if the battery overvoltage fault occurs
Sound G: This type of signal is emitted when the system test fails. The buzzer emits ten beeps. The alarm signal is
maintained by the "batteries to be replaced" LED lights up.
- 104 -