Herunterladen Inhalt Inhalt Diese Seite drucken

12. Maintenance; Recommended Lubricants/Oil Mist Lubricator; Cleaning And Servicing; Service Intervals - Beissbarth MT 788 Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
en
44 | MT 788 | Maintenance

12. Maintenance

12.1
Recommended lubricants/oil mist
lubricator
Component
Lubricant
Compressed air system
ESSO FEBIS K 32
Tab. 2:
Lubricant table
!
The manufacturer cannot accept any liability for da-
mage arising from the use of other lubricants.
12.2

Cleaning and servicing

!
Before cleaning and servicing, switch off MT 788 and
disconnect mains plug.
!
Do not use any solvent-based cleaning agents. Use
alcohol or similar cleaning agents for plastic parts.
The following work is essential to ensure proper opera-
tion and high performance of the MT 788:
12.2.1

Service intervals

Servicing
Clean moving mechanical parts, treat with spray oil
or kerosene and lubricate with engine oil or
a suitable grease.
Remove condensate.
Check the oil level in the oil mist lubricator.
Replace the oil in the oil mist lubricator.
Tab. 3:
Service intervals
12.2.2

Removing condensate

1. Turn the red knob at the bottom of the water separa-
tor counter-clockwise.
2. Remove the accumulated condensate.
3. Turn back the red knob at the bottom of the water
separator.
|
932 655 638
2014-02-14
12.2.3

Topping up oil in oil mist lubricator

1. Remove the compressed air connection.
2. Screw the container to the oil mist lubricator.
3. Top up with oil.
Standard
ISO 32
12.2.4

Replacing oil in oil mist lubricator

1. Remove the compressed air connection.
2. Screw the container to the oil mist lubricator.
3. Drain off and dispose of the oil.
4. Fill with fresh oil.
12.3

Spare and wearing parts

The manufacturer cannot accept any liability for
damage arising from the use of non-genuine replace-
ment parts.
x
Designation
x
Standard centering flange
Centering cone 42 - 65 mm
x
Centering cone 54 - 80 mm
Centering cone 75 - 110 mm
x
Weight pliers
Manual vernier caliper
Test clip
Calibration weight
Calibration weight (calibrated)
Voltage sticker V 230
Voltage sticker V 110
Direction of wheel rotation sticker
Tab. 4:
Spare and wearing parts
Order number
1 695 602 400
761 632 500
931 145 234
931 145 030
761 606 500
761 629 400
1 695 602 700
761 654 377
1 695 654 376
1 695 101 269
1 695 100 854
1 695 653 878
Beissbarth GmbH

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis