Fitting And Removing The Flange; Removing The Flange; Fitting The Passenger Vehicle Flange; Fitting The Commercial Vehicle Flange - Beissbarth MT 788 Originalbetriebsanleitung

5. Fitting and removing the
flange
Fitting of the flange is necessary in the following
situations:
R
Commissioning
R
When changing the type of flange
(centering flange, universal flange, special flange)
R
When changing the type of wheel
(passenger car - truck)
!
Balancing accuracy will be impaired if the flange has
not been properly fitted to the shaft.Before fitting the
flange, clean and degrease (remove corrosion protec-
tion) the cone of the shaft and the flange opening.
5.1

Removing the flange

1. Slacken off the hexagon socket head bolt.
2. Unfasten the flange by tapping with a rubber-headed
hammer on the cone end.
3. Pull the flange off the cone.
"
Flange detached.
Beissbarth GmbH
Fitting and removing the flange | MT 788 | 33
5.2

Fitting the passenger vehicle flange

i
Clean and degrease the cone of the shaft and the
flange opening.
1. Slide the flange onto the shaft.
2. Tighten the hexagon socket head bolt.
"
Flange fitted.
5.3

Fitting the commercial vehicle flange

1. Use 2 bolts to attach the truck spacer ring to the
passenger vehicle flange.
2. Secure the commercial vehicle flange with 2 bolts.
en
|
932 655 638 2014-02-14