Circulation Of Coolant In The Cooler - Lincoln Electric COOLERTIG 3 Bedienungsanleitung

Circulation of Coolant in the Cooler

Figure 6.
WARNING
The ambient air temperature influences the parameters of
cooling. If the ambient temperature is higher, the cooling
system will be less effective.
WARNING
Avoid kinking or putting sharp bends in any water lines.
WARNING
Never operate the cooler with case off.
WARNING
Avoid placing the cooler near areas of extreme heat.
Preparation COOLERTIG 3 to Work

Fill the coolant reservoir.

Connect COOLERTIG 3 to power source.

Turn the power source on.
Warning: First use the cooler require the pump is
primed by coolant.

Turn power source off.

Connect the water-cooler hoses to the cooler's inlet [5]
and outlet [4] socket (Figure 8).

Turn the power source on.
Warning: The water-cooler hoses can require
bleeding.
English
Filling the reservoir and water lines
Avoid contact with coolant. Wear waterproof
gloves and protective eye wear.
Before filling the coolant reservoir, disconnect cooler's
power lead to the power source.
Warning: The cooler can be filled and used only in the
horizontal position.
Use only recommended
W000010167 (see "Accessories" chapter).
Do not use pre-packaged welding industry coolants.
These coolants may contain oil-based substances, which
attack the plastic components of the cooler. Once added
to the cooler, these substances are impossible to purge
from the water lines and heat exchanger.
Do not use automotive anti-freeze. These coolants will
damage the pump and block of the heat exchanger,
affecting cooling performance.
The coolant reservoir can be filled maximum 3,6l coolant.
Minimum 2,5l of coolant has to be poured into the
reservoir.
Never operate the cooler with the reservoir empty.
Do not start the cooler with less than 2,5l of coolant.
Operating without enough coolant can prevent full priming
of the system and may damage the pump.
8
WARNING
WARNING
coolant FREEZCOOL
WARNING
WARNING
WARNING
English
-