Atag CX4411T Bedienungsanleitung Seite 235

SAFETY (CONTINUED)
Installation
Check the appliance for transport damage. Do not
•
connect a damaged appliance.
This appliance should only be connected by a registered
•
installer!
Faulty parts may only be replaced by original parts. The
•
manufacturer can only guarantee that original parts meet
safety requirements.
To avoid dangerous situations, a damaged connecting
•
cable should only be replaced by the manufacturer, the
manufacturer's service organisation or suitably qualifi ed
persons.
The electrical connection must comply with national and
•
local regulations.
The wall plug socket and plug should always be
•
accessible.
If you want to make a fi xed connection, make sure that a
•
omnipolar switch with a contact separation of at least
3 mm is fi tted in the supply cable.
The equipment should not be connected to the network
•
via a multi-plug socket or extension lead, as the safe use
of the equipment can then not be guaranteed.
WARNING: Never open the appliance casing. The casing
•
may only be opened by a service technician.
Disconnect the appliance from the mains supply before
•
starting any repair work.
Freestanding micro wave ovens shall not be placed in a
•
cabinet.
If the safety instructions and warnings are not followed,
the manufacturer cannot be held responsible for any
resulting damage.
If you decide to discontinue using the appliance because
of a fault, we recommend you cut off the cable after
removing the plug from the plug socket. Take the appliance
to your municipality's waste disposal site.
EN 13