Storage And Transport; Maintenance - Scheppach ASP30PLUS Original Bedienungsanleitung

Empty the stainless steel container (8)
after each use: After opening the screw
cap (7) to drain out the liquids, the liquid
collected can be drained out. Residual
liquid remains in the stainless steel con-
tainer (8).
To remove residual liquid, take off the ma-
chine head (2) by releasing the locking
hooks (4) from the stainless steel contain-
er (8). Pour out the liquid residue. Clean
the container with a damp cloth.
• Replace paper filter bag when full
• Always keep the device clean. Do not
use cleaning agents or solvents.
• Keep the ventilation slots clean and free
of dirt and dust.
• Clean the device only with a soft brush
or a damp cloth.
• Clean the foam filter (b) with a little soap
and running water and then leave it to
air dry.
Cleaning function
When vacuuming dry and fine dust, the
filter may become dirty. To clean the filter,
proceed as follows.
• Press the release button for lever (15).
The lever (16) is released.
• Move the lever (16) up and down until
the filter is free of dust and dirt.

11. Storage and Transport

Store the device and its accessories in a
dark, dry and frost-proof place that is in-
accessible to children. The optimum stor-
age temperature is between 5 and 30˚C.
Store the electrical tool in its original
packaging.
26 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Cover the electrical tool in order to pro-
tect it from dust and moisture.
Store the operating manual with the elec-
trical tool.
• Wind the mains cable (3) around the
top cable holder (12). (Fig. R)
• There are four recesses on the top side
of the caster mounting base (6) for stor-
ing the floor nozzle (e) and the joint noz-
zle (f). (Fig. S)
• On the machine head (2) there is a hold-
er for the metal extension tube (g). The
remaining accessories can be stored in
the stainless steel container (8).

12. Maintenance

Warning!
Disconnect the mains plug before carry-
ing out any maintenance work.
Connections and repairs
Connections and repairs of electrical
equipment may only be carried out by an
electrician.
Please provide the following informa-
tion in the event of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Motor data - type plate
Service information
Please note that the following parts of
this product are subject to normal or nat-
ural wear and that the following parts are
therefore also required for use as con-
sumables. Wear parts*: Foam filter, Paper
filter bag, Folded filter for dry vacuuming
* Not necessarily included in the scope of
delivery!