Operation; Cleaning - Scheppach ASP30PLUS Original Bedienungsanleitung

9. Operation

m WARNING!
Always make sure the device is fully as-
sembled before start-up!
m WARNING!
Switch the device off if liquid or foam
emerges with the exhaust air during wet
vacuuming.
Switch on / switch off / automatic (Fig.
M, N)
The ON/OFF switch (11) has three set-
tings:
1. Switch setting 0: Off
2. Switch setting II: On
- Press the on/off switch (11) on posi-
tion "II" tu turn on the device.
- Press the on/off switch (11) on posi-
tion "0" to turn off the device.
3. Switch setting I: Automatic mode (the
vacuum cleaner will be switched on by
an electric tool).
• Plug your electrical tool's cable into the
automatic socket (10) (fig. N).
• Connect the suction hose (a) to the suc-
tion connection (9) on your electrical
tool. Check that the connection is se-
cure and airtight.
• Set the switch on the vacuum system to
position "I" = Automatic mode.
Dry vacuuming (Fig. G, H)
Use the folded filter (d) for dry vacuum-
ing. The paper filter bag (c) can be used in
addition. This ensures that the folded fil-
ter (d) remains free of dust for longer and
maintains the vacuum power for longer.
In addition, the disposal of the dust is also
easier.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Always ensure that the filters are correctly
fitted.
Wet vacuuming (Fig. F)
Use the foam filter (b) for wet vacuuming.
Ensure that the foam filter (b) is correctly
fitted.
If the stainless steel container (8) is full,
the safety float valve (14) closes the suc-
tion port and suction operation is inter-
rupted.
m IMPORTANT!
The device is not suitable for vacuuming
flammable liquids. For wet vacuuming,
use the only the foam filter (b) provided.
Water drain plug (7) (Fig. O)
The stainless steel container (8) is
equipped with a water drain plug (7) in or-
der to make it easier to drain. Open the
water drain plug (7) by turning it coun-
ter-clockwise and drain out the liquid.

10. Cleaning

m WARNING!
Prior to any adjustment, maintenance or
service work disconnect the mains power
plug!
Cleaning
It is recommended to clean the device af-
ter each use. Do not spray the device with
water or clean it under running water. This
can result in electric shocks and can dam-
age the device.
GB | 25