Herunterladen Inhalt Inhalt Diese Seite drucken

What To Do If - Electrolux ehs90270x Benutzerinformation

Glaskeramik-kochfeld
Vorschau ausblenden Andere Handbücher für ehs90270x:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

move residues by sliding the blade over
the surface. Wipe the appliance with a
damp cloth and a little washing up liquid.
Finally, rub the appliance dry using a
clean cloth .

What to do if...

Problem
The cooking zones will not
switch on or are not functioning
Acoustic signal sounds when
appliance is switched off
The residual heat indicator is not
displaying anything
Acoustic signal sounds and ap-
pliance switches itself on and
then off again; after 5 seconds
another acoustic signal sounds
is lit
and number are displayed
If you are unable to remedy the problem
by following the above suggestions,
please contact your dealer or the Cus-
tomer Care Department.
Warning! Repairs to the appliance are
only to be carried out by qualified service
2. Limescale rings, water rings, fat
Possible cause
More than 10 seconds have
passed since the appliance was
switched on
The child safety device is switch-
ed on
Several sensor fields were
touched at the same time
Automatic switch off has been
triggered
There is water on the control
panel, or the control panel is
covered with splashes
is active
The control panel is wholly or
partly covered by objects.
There is water or fat splashes on
the control panel
The cooking zone was only on
for a short time and is therefore
not hot
The On/Off sensor field has
been covered up, e.g. by a cloth
Automatic switch-off has been
triggered
Electronics fault
splashes, shiny metallic discolorations
should be removed after the appliance
has cooled down using cleaner for glass
ceramic or stainless steel.
Switch the appliance on again.
Deactivate child safety device
(See the section "Child safety
device")
Only touch one sensor field
Remove any objects (pan,
cloths, etc.) that are lying on the
control panel. Switch the appli-
ance on again
Wipe the control panel
Switch off
Remove objects.
Wipe the control panel
If the cooking zone is supposed
to be hot, call the Customer
Service Department.
Do not place any objects on the
control panel
Switch off the cooking zone.
Switch the cooking zone on
again
Disconnect the appliance from
the electrical supply for a few mi-
nutes (Take the fuse out of the
house's wiring system) If after
switching on again,
played again, call the customer
service department
engineers. Considerable danger to the
user may result from improper repairs.
electrolux 11
Remedy
is dis-

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis