What To Do If - Electrolux EHD60020P Benutzerinformation

For your safety, do not clean the appli-
ance with steam blasters or high-pres-
sure cleaners.
Scratches or dark stains on the glass
ceramic have no effect on how the ap-
pliance operates.
To remove the dirt:
1. – Remove immediately: melted plas-
tic, plastic foil, and food with sugar. If
not, the dirt can cause damage to the
appliance. Use a special scraper for

WHAT TO DO IF...

Problem
You cannot start the appliance
or operate it.
A sound operates when the ap-
pliance is off.
A sound operates 6 times, the
appliance stops.
The residual heat indicator does
not come on.
The automatic warm up function
does not start.
A sound operates and appliance
starts and stops again. After 5
seconds one more sound oper-
ates.
Sensor fields become hot.
The display changes between
two heat settings.
comes on.
– Remove after the appliance is suf-
2. Clean the appliance with a moist cloth
and some detergent.
3. At the end rub the appliance dry with
a clean cloth.
Possible cause and remedy
• The key lock or child safety device operates
tion. See the section "Locking/unlocking the control panel"
and "Child safety device".
• STOP+GO operates
"Stop and go".
• You touched 2 or more sensor fields at the same time. Only
touch one sensor field.
• There is water or fat stains on the control panel. Clean the con-
trol panel
• Start the appliance again and set the heat setting within 10 sec-
onds.
You covered one or more sensor fields. Uncover the sensor fields.
You covered one or more sensor fields. Uncover the sensor fields.
The cooking zone is not hot because it operated only for a short
time. If the cooking zone must be hot, speak to the after sales
service.
• There is still residual heat on the cooking zone
cooking zone cool down
• The highest heat setting is set. The highest heat setting has
the same power as the automatic warm up function.
You covered . Uncover the sensor field.
The cookware is too big or you put it too near the controls. Put
large cookware on the rear cooking zones if necessary.
Power Management decreases the power of this cooking zone.
Use cooking zones on the other side.
• The automatic switch-off operates. Stop the appliance and
start it again.
Overheating protection for the cooking zone operates. Stop the
cooking zone and start it again.
the glass . Put the scraper on the
glass surface at an acute angle and
move the blade on the surface .
ficiently cool: limescale rings , water
rings, fat stains, shiny metallic discol-
orations. Use a special cleaning agent
for glass ceramic or stainless steel.
. Stop the function. See the section
electrolux 41
. Stop the func-
. Let the