Fora Diamond PRIMA Bedienungsanleitung Seite 11

is preceded by two quick beeps. So you will hear: 2 quick beeps
– results – 2 quick beeps – results – 2 quick beeps – result.
For mg/dL meters, the hundreds are always announced, even
when the result is below 100.
Examples:
80 mg/dL is announced as 1 long beep (0) – 1 single pause – 8
single beeps (8) – 1 single pause – 1 long beep (0)
182 mg/dL is announced as 1 single beep (1) – 1 single pause –
8 single beeps (8) – 1 single pause – 2 single beeps (2)
For mmol/L meters, the tens are always announced, even when
the result is below 10. The decimal point is represented by 1
quick beep.
Examples:
6.0 mmol/L is announced as 1 long beep (0) – 1 single pause – 6
single beeps (6) – 1 single pause – 1 quick beep (.) – 1 single
pause – 1 long beep (0)
Note:
Information or warnings in the form of symbols displayed together
with the results are not announced acoustically.
Disposing Used Test Strip and Lancet
To remove the used test strip, simply push the Test Strip
Ejector button upward to eject the used test strip. The device
will automatically turn off after the test strip is ejected.
To remove the used lancet, remove the lancet from the lancing
device after you have finished testing. Always follow the
instructions in the lancing device insert when removing the
lancet.
Important!
The used lancet and test strip may be biohazardous. Please
discard them carefully according to your local regulations.
Reviewing Test Results
Your device stores the 450 most recent test results along with
respective dates and times in its memory. To enter the device
memory, start with the device switched off.
To review all test results, do the following:
1. Press and release the Main button. The "
the screen.
2. Press the Main button to review the test results stored in the
device. Press the Main button repeatedly to review other test
results stored in the device. (q) After the last test result, press
the Main button again and the device will be turned off.
To review the day-average test results, do the following:
1. Press and hold the Main button for 3 seconds until the "
" icon appears. Release the Main button and then
your 7-day average result measured in general mode will
appear on the display.
2. Press the Main button to review 14-, 21-, 28-, 60- and 90- day
average results stored in each measuring mode in the order of
Gen, AC, then PC. (r)
Note:
• Keep pressing the Main button and the device will turn off after
displaying the last test result.
EN-7
PRIMA Owner's Manual
" icon appears on