Operation; First Use Of The Software; Connect To The Pce-Fm 200; Disconnect From The Pce-Fm 200 - PCE -FM 200 Bedienungsanleitung

6

Operation

6.1

First use of the software

Before the PCE-FM 200 can work with the software, the assigned COM port must be set in the
software once. It can be set via the "settings dialog"
In addition to entering the connection data, the settings for the date and time format and for the
decimal format can be made here.
6.2

Connect to the PCE-FM 200

After the desired settings have been made and the settings dialog has been closed with a click
on the "Apply" button, the connection to the PCE-FM 200 can be established by clicking on the
icon.
If the connection has been successfully established, the term "Connected" is displayed in green
on the status bar for the dynamic data.
If, however, no connection has been established, the term "Disconnected" is displayed in red.
6.3

Disconnect from the PCE-FM 200

By clicking on the
If you exit the software while the connection is active, the connection will also be terminated.
icon, an active connection to the PCE-FM 200 can be terminated.
© PCE Instruments
5