Factory Setting; Types Of Alarm; Error Condition And Reset; Table 2: Factory Settings - DAB Evoplus Small Serie Installationsanweisung Und Wartung

GB
ENGLISH
Page 13.0
On page 13.0 you can set the system status in ON or OFF.
If ON is selected the pump is always on.
If OFF is selected the pump is always off.
13. FACTORY SETTINGS
Parameter
Regulating mode
Twin operating mode
Pump start control

Table 2: Factory settings

14. TYPES OF ALARM

Alarm Code Alarm Symbol
e0 - e16; e21
e17 - e19
e20
e22 - e31
e32 - e35
e37
e38
e39 - e40
e46
e42
e56
24
Downloaded from www.Manualslib.com
Value
= Proportional differential pressure
regulation
= Alternate every 24h
ON
Alarm Description
Internal Error
Short Circuit
Voltage Error
Internal Error
Electronic system excess temperature
Low voltage
High voltage
Pump blocked
Pump Disconnected
Dry operation
Motor excess temperature (motor
protector trips)
manuals search engine
e57
e58

Table 3: List of alarms

15. DISPOSAL
This product or any part of it must be disposed of correctly:
1. Use public or private local systems for waste collection.
2. If that is not possible, contact Dab Pumps or the nearest authorised
service workshop.
INFORMATION
Frequently asked questions (faq) on the ecodesign directive 2009/125/
ec establishing a framework for the setting of ecodesign requirements for
energy-related products and its implementing regulations:
http://ec.europa.eu/enterprise/policies/sustainable-business/docu-
ments/eco-design/guidance/files/20110429_faq_en.pdf
Guidelines accompanying commission regulations implementing the
ecodesign directive:
http://ec.europa.eu/energy/efficiency/ecodesign/legislation_en.htm
- see "circulators.

16. ERROR CONDITION AND RESET

Display
Description
indication
e0 – e16 Internal error
Frequency of PWM external signal less
than 100 Hz
Frequency of PWM external signal
greater than 5 kHz
Reset
- Switch off system power.
- Wait for the warning lights on the control
panel to go off, then power the system
again.
- If the error persists, change the circu-
lator.