Safety Guidelines For Battery Chargers; Before Use; Charging The Battery Pack (See Fig. A) - Parkside PDSSA 20-Li A1 Originalbetriebsanleitung

Safety guidelines for battery chargers

This appliance may be used by
■
children aged 8 years and above
and by persons with limited phys-
ical, sensory or mental capabilities
or lack of experience and know-
ledge, provided that they are under
supervision or have been told how
to use the appliance safely and are
aware of the potential risks. Do not
allow children to use the appliance
as a toy. Cleaning and user mainte-
nance tasks may not be carried out
by children unless they are super-
vised.
To avoid potential risks, damaged
■
mains cables should be replaced
by the manufacturer, their customer
service department or a similarly
qualified person.
The charger is suitable for
indoor use only.
WARNING!
■ To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or a
similarly qualified person.
ATTENTION!
♦ This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/PAP 20 A3.
♦ A current list of battery compatibility can be
found at www.lidl.de/Akku.
ATTENTION!
Hot surface.
Risk of burns.
PDSSA 20-Li A1

Before use

Charging the battery pack
(see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage climate
should be cool and dry and the ambient
temperature should be between 0°C and
50°C.
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket. The
control LED lights up red.
♦ The green control LED
charging process is complete and the battery
pack is ready.
CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged.
♦ If the red and green control LEDs
flash, this means that the battery pack
defective.
♦ Insert the battery pack
appliance.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
to the rapid
(see Fig. A).
indicates that the
flashes, this means
has overheated and
both
back into the
GB │ MT │
47
is
■