Safety Instructions Specifically For Impact Screwdrivers; Safety Guidelines For Battery Chargers; Before Use; Charging The Battery Pack (See Fig . A) - Parkside PASSK 20-Li A1 Originalbetriebsanleitung

Safety instructions specifically for
impact screwdrivers
■ Wear hearing protection when impact
screwing. Exposure to loud noise can lead
to hearing loss .
■ Secure the workpiece! A workpiece securely
held by a clamping device or vice is much safer
than one held in your hand .
■ Hold the power tool firmly. High torques can
occur for brief periods while tightening and
loosening screws .
■ Wait until the power tool has come to a stand-
still before putting it down. The tool can jam,
this leading to loss of control of the power tool .
■ Hold the power tool by the insulated gripping
surfaces, when performing an operation where
the screw or attached tool could come into
contact with hidden wiring. Contact between the
screw or attached tool and a live wire may cause
exposed metal parts of the power tool to become
live and give the operator an electric shock .

Safety guidelines for battery chargers

This appliance may be used by
■
children aged 8 years and above
and by persons with limited physical,
sensory or mental capabilities or
lack of experience and knowledge,
provided that they are under super-
vision or have been told how to use
the appliance safely and are aware
of the potential risks . Do not allow
children to use the appliance as a
toy . Cleaning and user maintenance
tasks must not be carried out by
children unless they are supervised .
To avoid potential risks, damaged
■
mains cables should be replaced
by the manufacturer, their customer
service department or a similarly
qualified person .
■ 6 │ GB │ IE │ NI
The charger is suitable for indoor use
only .
WARNING!
■ To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or a
similarly qualified person .
ATTENTION!
Hot surface .
There is a risk of burns .

Before use

Charging the battery pack (see fig . A)

CAUTION!
► Always pull out the power plug before you
remove the battery pack from or connect the
battery pack to the charger .
■ Never charge the battery pack
ambient temperature is below 10°C or above
40°C .
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket . The control
LED lights up red .
♦ The green LED indicates that the charging
process is complete and the battery pack
is ready for use .
CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged .
♦ If the red and green control LEDs
flash, this means that the battery pack
defective .
♦ Push the battery pack
♦ Switch off the charger for at least 15 minutes
between successive charging sessions . Also dis-
connect the power plug from the mains power
socket .
when the
to the high-speed
(see Fig . A) .
flashes, this means
has overheated and
both
back into the appliance .
PASSK 20-Li A1
is