Remote Control - Yamaha RDX-E700 Bedienungsanleitung

Problem
The DVD receiver does not
operate properly.
A digital equipment or
high-frequency equipment
produces noises.
Sound played on the DVD
receiver cannot be
recorded with an external
recorder.
The clock setting has
been cleared.

Remote control

Problem
The remote control does not
work for operating the DVD
receiver.
The remote control does not
work for operating TV.
Cause
The DVD receiver may receive a
strong electrical shock, such as from
a lightening bolt or excessive static
electricity, or drop in power supply.
The DVD receiver may be placed
close to the digital equipment or
high-frequency equipment.
You may be trying to make a digital
recording with an analog source.
The power to the DVD receiver may
be lost more than a week.
Cause
The remote control may be operated
outside the remote control operation
range.
The remote control sensor on the
DVD receiver may be exposed to
direct sunlight or lighting (inverted
fluorescent lamps).
The remote control mode selection
may be improper.
The batteries may be worn out.
The remote control code may be
incorrect.
TROUBLESHOOTING
Solution
Set the DVD receiver to the Standby mode,
then disconnect the power cable. Wait for
about 30 seconds, then connect the power
cable and turn on the DVD receiver.
Place the DVD receiver further away from
such equipment.
Use proper audio sources.
Make sure the power cable is plugged into
outlet firmly, then set the clock again
(page 16).
Solution
For information on the remote control
operation range, refer to "USING THE
REMOTE CONTROL" (page 13).
Change the lighting or DVD receiver's
orientation.
Select the mode that suits your purpose
(page 5).
Replace the batteries with new ones.
(page 13).
Set the correct remote control code
(page 42). Depending on the model and
year of the product, the remote control
may not be able to operate it partly or
wholly. In this case, use the remote
control supplied for the product.
45