GF Signet 9900-1BC Produktanleitung Seite 25

Specifi cations
General
Input channels .....One
Enclosure and Display
Case Material ......PBT
Window ............... Shatter-Resistant Glass
Keypad ................ 4 buttons, injection-molded
silicone rubber seal
Display ................. Backlit, 7- and 14-segment
Indicators ............. "Dial-type" digital bar
graph
Update rate .........1 s
LCD Contrast ......5 settings
Enclosure
Size .....................¼ DIN
Color ....................Black
Mounting
Panel ................... ¼ DIN, ribbed on four
sides for panel mounting
clip inside panel
Wall ...................... Large enclosure
(sold as an accessory) that
encases the transmitter
Environmental Requirements
Ambient operating temperature:
Backlit LCD ............. -10 °C to 70 °C
Storage Temp .......... -15 °C to 70 °C
Operating Temp ....... -10 °C to 70 °C
Relative Humidity .... 0 to 100% condensing
Maximum Altitude .... 4,000 m (13,123 ft)
Enclosure Rating Designed to meet NEMA
4X/IP65 (front face only).
Performance Specifi cations
System Response:
• Primarily dependent upon the sensor.
Transmitter adds a maximum 300 ms
processing delay of the sensor
electronics.
• System response is tempered by the
display rate.
(14 °F to 158 °F)
(5 °F to 158 °F)
(14 °F to 158 °F)
for front only; 0 to 95%
non-condensing for
back side.
Electrical Requirements
Power to Sensors:
Voltage .................... +4.9 to 5.5 VDC @
Current .................... 20 mA max
Short Circuit ............ Protected
Terminal Blocks
• Pluggable screw type
• 14 AWG max wire gauge
Input Power Requirements
DC (preferred) ......... 24 VDC Input; range:
Overvoltage
protection ............ 48 Volt Transient
Current limiting for circuit protection
Reverse-Voltage protection
Loop Characteristics
With DC power input (preferred)
Max. loop impedance
@ 12 V loop power
@ 18 V loop power
@ 24 V loop power
Relay Specifi cations
Hysteresis ............... Adjustable (absolute
Latch ........................ Reset in test screen
On Delay ................. 9999.9 seconds (max)
Test Mode ................ Set On or Off
Maximum
pulse rate ............ 400 pulses/minute
Volumetric
Pulse Width ......... 0.1 s to 3200 s
Open Collector
Type ......................... NPN
Max. Voltage Rating 30 VDC
Max. Current Rating 50 mA
Dry-Contact Relays
Type ......................... SPDT
Form ........................ C
Max. Voltage Rating...30 VDC or 250 VAC
Max. Current Rating...5 A
Shipping Weights
Base Unit ................. 0.63 kg (1.38 lb)
Batch Module .......... 0.16 kg (0.35 lb)
Relay Module .......... 0.19 kg (0.41 lb)
9900-1BC Batch Controller Manual
25 °C, regulated
10.8 to 35.2 VDC
regulated 300 mA
maximum
Protection Device
250 Ω max.
500 Ω max.
750 Ω max.
in Engineering Units)
or View Mode
25