Activated Carbon Filter - GUTMANN APILAR Bedienungsanleitung

EN
Replace the metal filter after the cleaning process. Then push them together into
the filter shaft until magnetic adhesion occurs.
Reinsert the metal filter after the cleaning process, then press and hold the remote
switch (1) ON/OFF for 10 seconds. The operating hours counter is reset and the red
LED ( F = filter saturation ) goes out. ( Device must be in ON mode ).
Activated carbon filter change
Activated carbon filters bind odorous substances contained in kitchen fumes. Depen-
ding on the strain, these filters must be replaced after 3 months at the latest.
The activated carbon filter is mounted with a frame to the left and right of the fan modu-
le in the upper hood body.
Pull out the filter housing using the red tab.
After pulling out, hold the filter housing horizontally or with the opening facing
upwards ! ( activated carbon filter is unsecured )
Remove the used filter element and replace it with a new one. Then push it
together into the filter shaft until magnetic adhesion occurs.
Carbon-Filter ( Part.Nr.: TZ463 )
Disposable filter
no regeneration possible !
23