Connection To Power Supply; Danger Of Electric Shock - GUTMANN APILAR Bedienungsanleitung

EN
Transport, unpacking, installation
Condensation may occur if the appliance is brought into the instal-
lation site from a cold environment. Please wait until the appliance
has adjusted to the temperature and is completely dry before ope-
rating it. The acclimatization period depends on the temperature
difference and the type and design of the appliance. However, it
should be at least 12 hours.

Connection to power supply

Check that the rated voltage of the device corresponds to the local mains voltage. In-
correct setting will damage or destroy the device.
Before operation, check whether all cables and wires are faultless and undamaged. In
particular, make sure that the cables have no kinks, have not been laid too short
around corners and that there are no objects on the cables. Furthermore, make sure
that all plug connections are tight. Faulty shielding or wiring endangers your health
(electric shock) and can destroy other equipment. Devices with a mains plug are equip-
ped with a safety-tested mains cable from the country of use and must only be connec-
ted to a properly earthed earth contact socket, otherwise there is a risk of electric
shock. Make sure that the socket at the device or the earth contact socket of the house
installation is freely accessible so that the mains cable can be disconnected from the
socket in an emergency or during service or maintenance work.

Danger of electric shock !

Do not clean the hood with a steam cleaner or water pressure. When cleaning the
hood, it must first be disconnected from the power supply.
Danger of crushing !
When inserting the filters and closing the covers, please make sure that there are no
body parts in between.
Design
From an aesthetic perspective, the extractor hood may differ from the drawings in the-
se operating instructions. However, the operating instructions, maintenance, cleaning
and installation procedures are always the same. The drawings and plans must be
consulted in the case of customer-specific products.
18