Operating Instructions; Operation Via Remote Control - GUTMANN APILAR Bedienungsanleitung

EN

Operation via remote control

ON / OFF (1)
To switch on, press the field with the ON / OFF symbol. The fan starts at power level 1
and the first two LED shine. To switch off, press the ON / OFF symbol again.
Increase fan power (2)
Press the Increase fan power icon. The fan power increases by one power level each
time the button is pressed.
Reduce fan power (3)
Press the Reduce fan power icon. The fan power decreases by one power level up to
power level 1 with each press.
Intensive level (5)
The maximum fan output is reached by pressing the Intensive level button. The fan
power switches back by one power level after 5 minutes.
Automatic follow-up time (6)
Touching the field with the follow-up time symbol activates the automatic follow-up time
at level 3 and the follow-up time symbol flashes. The cooker hood switches back from
level 3 to levels 2 and 1 at 5-minute intervals and switches off definitively after ~15 min.
Filter saturation indicator (F)
(automatic display after 15 operating hours)
The filter saturation indicator will be reset by pressing the key (1) (~10 sec.) until the
red LED turns off. ( Device must be in ON mode ).
Illumination (4)
( Ambient-light will be activated by toggle switch 7b )
Press the button with the light icon to turn on the hob light.
Press the button again to switch on the ambient lighting. Press
again to switch off the hob lighting. Press again to switch off the
ambient lighting. If the lighting symbol is held down for a longer
time, the hob lighting is dimmed.
Colour temperature setting
( hob lighting only )
The colour temperature of the LED hob lighting can be infinitely
adjusted between 2700K and 6500K.
Press and hold the delay button (6) to adjust, the LEDs start to
change the colour temperature. When the desired setting is
reached, release the button, the colour setting is saved.
Dimming function Ambient lighting
Press and hold the Intensive level button (5) (>10 sec.) to dim
the ambient lighting and keep it at the brightness level reached
when the button is released.
Note : If the RC functions are limited or not available
please check battery capacity first.
20

OPERATING INSTRUCTIONS

int
int