Cleaning The Grease Filter - GUTMANN ESTRELLA TYP EM 06 Bedienungsanleitung

en
remove any grease deposits from the
accessible housing components. This
will prevent a fire hazard and maintain
an optimum range of functions. Use hot
soapy water or a mild window cleaning
agent to clean the hood. Do not scratch
off baked-on deposits. Soften them us-
ing a damp cloth. Do not use abrasive
agents or scouring pads.
Note: Do not use alcohol (spirits) on
plastic surfaces, as dull spots may re-
sult.
Caution: Ventilate the kitchen sufficient-
ly, no open flame.
Only clean the operating panel with a
soft damp cloth (mild detergent solu-
tion). Do not use stainless steel cleaners
for the sliding switch/pressure switch.
Stainless steel surfaces:
Use a mild and non-abrasive stainless
steel cleaning agent. Do not clean stain-
less steel surfaces with abrasive scour-
ing pads or with cleaning agents con-
taining sand, soda, acid or chloride!
Clean in direction of polish only.
We recommend our stainless steel
cleaner no. 461731. See the enclosed
service booklet for the order address.
Use a soft micro fibre cloth. Do not use
dry cloths. Use a mild window-cleaning
agent. Do not use aggressive cleaning
agents or agents containing acid or lye!
Do not use scouring agents.

Cleaning the grease filter

Fire hazard!
The performance of the extractor hood
is impaired by greasy residues and the
fire hazard is increased by the deposits.
To prevent the risk of fire, we recom-
mend regular cleaning of the metal filter.
With the glass panel open, hold the met-
al filter by the filter grips and pull down
until the magnetic contact releases. Now
pull the metal filter out towards the front.
Filter installation in reverse order. The
necessary cleaning of the grease filter is
also indicated by the LED display after
15 operating hours, the red LED on the
roof unit begins to light up – then please
clean the filter.
cleaned in the dishwasher using a gen-
tle detergent. The manufacturer does
20
Metal filters are best
not assume any guarantee whatsoever
for any discolouration caused by the use
of aggressive
Temperatures exceeding 55 degrees
must also be avoided.
Switch off the extractor hood and pull
out the mains plug or switch off the
electricity supply at the fuse box.
Replace faulty lights through new ones
immediately.
Please cut the connection between the
extractor hood and the power supply
system!
The lightings remain hot for some time.
Please wait therefore for some time till
the lightings have cooled off.
After cooling-off the glass cover is to be
removed with a small screwdriver. Then
cleaning agents.