Cleaning And Maintenance; Spare Parts And Accessories - 3M PELTOR Tactical XP MT1H7x2 Serie Handbuch

CLEANING AND MAINTENANCE

Use a cloth wetted with soap and warm water to clean the
outer shells, headband and ear cushions.
NOTE: Do NOT immerse the hearing protector in water.
If the hearing protector gets wet from rain or sweat, turn the
earmuffs outwards, remove the ear cushions and foam liners,
and allow to dry before reassembly. The ear cushions and
foam liners may deteriorate with use and should be examined
at regular intervals for cracking or other damage. When
used regularly, 3M recommends replacing the foam liners
and ear cushions at least twice a year to maintain consistent
attenuation, hygiene, and comfort. If an ear cushion is
damaged, it should be replaced. See Spare Parts Section
below.
REMOVING AND REPLACING THE EAR CUSHIONS
E:1 To remove the ear cushion, slide your fingers under the
inside edge of the ear cushion and firmly pull straight out.
E:2 Remove existing liner(s) and insert new foam liner(s).
E:3 Fit one side of the ear cushion into the groove of the
earcup and then press on the opposite side until ear cushion
snaps in place.

SPARE PARTS AND ACCESSORIES

3M™ PELTOR™ HY79 Hygiene kit
Replaceable hygiene kit. Replace at least twice a year to
ensure constant attenuation, hygiene and comfort.
3M™ PELTOR™ HY100A Single-use protectors
Single-use protector that is easy to fit to the ear cushions.
3M™ PELTOR™ HYM1000 Microphone protector
Moisture- and wind-resistant tape that protects the speech
microphone.
3M™ PELTOR™ M41/2 Wind protection for the
microphones
WARRANTY AND LIMITATION OF LIABILITY
WARRANTY: In the event any 3M Personal Safety Division
product is found to be defective in material, workmanship,
or not in conformity with any express warranty for a
specific purpose, 3M's only obligation and your exclusive
remedy shall be at 3M's option, to repair, replace or
refund the purchase price of such parts or products upon
timely notification of the issue by you and substantiation
that the product has been stored, maintained and used
in accordance with 3M's written instructions. EXCEPT
WHERE PROHIBITED BY LAW, THIS WARRANTY IS
EXCLUSIVE AND IS IN LIEU OF ANY EXPRESS OR
IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS
FOR A PARTICULAR PURPOSE OR OTHER WARRANTY
OF QUALITY, OR THOSE ARISING FROM A COURSE OF
DEALING, CUSTOM OR USAGE OF TRADE, EXCEPT OF
TITLE AND AGAINST PATENT INFRINGEMENT. 3M has no
obligation under this warranty with respect to any product that
has failed due to inadequate or improper storage, handling,
or maintenance; failure to follow product instructions; or
alteration or damage to the product caused by accident,
neglect, or misuse.
LIMITATION OF LIABILITY: EXCEPT WHERE PROHIBITED
BY LAW, IN NO EVENT SHALL 3M BE LIABLE FOR
ANY DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR
CONSEQUENTIAL LOSS OR DAMAGES (INCLUDING
LOST PROFITS) ARISING FROM THIS PRODUCT,
REGARDLESS OF THE LEGAL THEORY ASSERTED.
THE REMEDIES SET FORTH HEREIN ARE EXCLUSIVE.
NO MODIFICATION: Modifications to this device shall
not be made without the written consent of 3M Company.
Unauthorized modifications may void the warranty and the
user's authority to operate the device.
NOTE:
• Do not mix old and new batteries.
• Do not mix alkaline, standard, or rechargeable batteries.
• To properly dispose of the battery, follow local solid waste
disposal regulations.
• If the headset allows for recharging: Do not charge
alkaline batteries as this may cause damage to the
headset.
• Only use AA non-rechargeable or Ni-MH rechargeable
(as applicable) batteries.
4
EN