Cleaning And Maintenance; Replacing The Batteries; Spare Parts And Accessories - 3M PELTOR WorkTunes Pro HRXS220A Bedienungsanleitung

Store station
Press and hold the On/Off/Mode button to store station while you are in search station mode. To access your
preset stations push the On/Off/Mode button till you hear the voice message, "Stored station". Press + or – to
browse preset stations.
Changing radio AM/FM band (only specific models)
Press the On/Off/Mode button to change radio band. A voice message will confirm, "Radio band". Press the + or
the – button to change radio band.
Listening via the 3.5 mm external input jack Connect an external device via the 3.5 mm input jack using a 3.5
mm cable (purchase separately). Press the – button to set the radio volume on the lowest level and mute to
enable listening to the external device. Adjust the sound level on the external device.
Automatic power off
The unit will automatic power off after four hours of inactivity. This is indicated by a voice message, "Automatic
power off" followed by a series of short tones, then the unit will power off. Press any button to avoid automatic
power off.

CLEANING AND MAINTENANCE

Use a cloth wetted with soap and warm water to clean the outside of the cups, headband and cushions.
NOTE: Do NOT immerse the hearing protector in water.
If the hearing protector gets wet from rain or sweat, turn the earmuffs outwards, remove the cushions and foam
liners, and allow to dry before reassembly. The cushions and foam liners may deteriorate with use and should be
examined at regular intervals for cracking and leakage. When used regularly, 3M recommends replacing the
foam liners and cushions at least twice a year to maintain consistent attenuation, hygiene, and comfort. If a
cushion is damaged, it should be replaced. See Spare Parts Section below. Keep the earmuffs clean and dry and
store at normal room temperature in a clean uncontaminated area before and after use.
REMOVING AND REPLACING THE CUSHIONS
G:1 To remove the cushion, slide your fingers under the edge of the cushion and firmly pull straight out.
G:2 To replace, insert the foam liner. Make sure that you choose the correct thickness of the foam liner. The
thickness of the new foam liner should correspond to the one you are replacing.
G:3 Then, fit one side of the cushion into the groove of the cup and then press on the opposite side until cushion
snaps in place.

REPLACING THE BATTERIES

Detach the latch H:1 with your fingers.
H:2 Open the cup.
H:3 Insert or replace the batteries. Make sure the polarity corresponds to the markings.
H:4 Close the cup and lock the latch.

SPARE PARTS AND ACCESSORIES

3M™ PELTOR™ HY220 Hygiene Kit
Hygiene kit consisting of two (DK034) thin foam liners, two (DK042) thick foam liners and two snap- in cushions.
3M™ PELTOR™ HY100A Clean – Single-Use Protectors
Single-use protector for the cushions. Package of 100 pairs.
3M™ PELTOR™ FL6CE 3.5 mm cable
3.5 mm cable to connect an external device
8