Kärcher MC 250 Handbuch Seite 51

Reversing camera active
2-wheel steering activated
2-wheel steering ready for selection
4-wheel steering activated
4-wheel steering ready for selection
Cruise control activated
Cruise control inactive
Cruise control (resume)
Activate the previously set speed
Hydraulic controller offline
Display offline
Neutral position (middle position) of the travel
direction selector switch required
Steering error
Seat contact switch not recognized
Seat storage active
Service required
Preheating active
General malfunction (non-critical), check error
list
Fuel level warning
Perform the regeneration process
Engine malfunction (non-critical)
Exhaust temperature high (regeneration is ac-
tive)
Regeneration is active (inhibit)
Vehicle power is limited, speed is limited
Warning, vehicle is in limited condition (trans-
port mode)
Battery charge status warning
Low hydraulic oil level warning
Hydraulic oil filter malfunction
Hydraulic oil temperature too high warning
Seat contact switch malfunction
Engine air filter malfunction
Critical malfunction, switch off the engine
Engine coolant temperature too high warning
Parking brake active
Reversing signal off
English 51