Special Safety Advice For Abrading Using Sandpaper; Special Safety Advice For Polishing; Special Safety Advice For Working With Wire Brushes; Safety Advice Applicable Specifically To Cordless Multi-Grinders - Parkside PFBS 9.6 A1 Bedienungs- Und Sicherheitshinweise

Special safety advice for
Q
abrading using sandpaper
J Do not use over-sized sanding sheets.
Follow the manufacturer's recommen-
dations for sanding sheet size. Sanding
sheets that project beyond the backing pad
could cause injury in addition to jamming,
tearing of the sheet or kickback.
Special safety
Q
advice for polishing
J
Do not use the polishing bonnet if it
has any loose parts, in particular the
fastening cords. Tuck the fastening cords
away or trim them. Loose fastening cords rotat-
ing with the attachment could catch your fingers
or become trapped in the workpiece.
Special safety advice for
Q
working with wire brushes
a) Bear in mind that wire brushes lose
pieces of wire during normal use. Do
not overload the wires by applying too
much pressure. Flying pieces of wire can very
easily penetrate thin clothing and / or skin.
b) Use a guard, if recommended, but
make sure that the wire brush does
not come into contact with the guard.
The diameters of disc brushes and cup brushes
can increase due to contact pressure and cen-
tripetal forces.
Safety advice applicable
specifically to cordless
multi-grinders
J
safety glasses and protective gloves.
Downloaded from www.Manualslib.com
When you use the drill / grinder wear
the following protective equipment:
manuals search engine
General safety advice for electrical power tools
CAUTION! RISK OF INJURY! The tool
J
piece. Use clamps or a vice to grip the workpiece
firmly. This is much safer than holding it in your
hand.
J
support yourself by placing your hands near or
in front of the device or the workpiece surface.
A slip can result in injury.
J
make sure that nobody is placed in any danger
and that there are no inflammable materials
near the working area.
J
harmful / noxious dusts generated from machin-
ing represent a risk to the health of the person
operating the device and to anyone near the
work area.
J
Ensure that there is adequate ventilation when
machining surfaces containing plastic or cov-
ered with paint, varnish etc.
J
Its use as a saw or the use of saw blades with
this device is prohibited.
J
Do not soak the materials or the surface you
are about to work on with liquids containing
solvents.
J
Avoid abrading paints containing lead or other
substances hazardous to health.
J
Do not machine materials containing asbestos.
Asbestos is a known carcinogen.
J
Avoid contact with moving sanding or grinding
tools.
J
Do not machine moist materials or damp sur-
faces.
NOTE! Do not allow the tool to come to a
standstill by overloading it!
J
Switch the device off and allow it to come to a
standstill before you put it down.
continues to rotate after it has been
switched off! Avoid contact with rap-
idly rotating drill / grinder components.
Securely support the work-
RISK OF INJURY! Never
DANGER OF FIRE FROM FLYING
SPARKS! Abrading metal creates
flying sparks. For this reason, always
DUST HAZARD! Any
Wear a dust mask!
NOXIOUS FUMES!
RISK OF INJURY!
GB/IE 13