Tuning The Electronic Control Unit To The Radio Remote Control; Eu Declaration Of Conformity; Technical Data - Truma Mover smart A Gebrauchsanweisung

Before contacting customer services, please check the
following:
– Are the batteries in the remote control in perfect condition?
– Is the remote control aligned with the control unit? Perform
the steps under "Tuning the electronic control unit to the
radio remote control" on page 17.
– Is the caravan battery in perfect condition and fully
charged? Please remember that battery performance can
deteriorate considerably at cold ambient temperatures.
If these measures do not rectify the problem, please
contact Truma Service.
Tuning the electronic control unit to the
radio remote control
During initial start-up or after replacement of the control unit
or the remote control, they must be tuned according to the
instructions below.
Ensure that the drive rollers are not in contact with the wheel.
Check for the proper connection and condition of the battery
and that 12 V are applied to the control unit.
– Establish the Mover power supply via the battery cut-off
switch. The green LED lights up
– Press the reset button (Figure 12 - 1) on the control unit
with a thin object.
For this purpose, you will find a removable pin under the
cover of the control unit (Figure 12 - 4). Then store the
pin in a convenient location.
The green (Figure 12 - 2) and red LED (Figure 12 - 3) on the
control unit now flash alternately.
– Switch on the remote control. The control unit and remote
control automatically connect. The green LED lights up.
Figure 12
1
2
3
4

EU declaration of conformity

Product
Function: Manoeuvring system
Type: Manoeuvring system
Version: Mover smart M, Mover smart A
Manufacturer
Truma Gerätetechnik GmbH & Co. KG
Wernher-von-Braun-Str. 12,
85640 Putzbrunn, Germany
The sole responsibility for drawing up this declaration of
conformity lies with the manufacturer.
The product complies with the relevant harmonisation
legislation of the European Union:
Directive 2014/53/EU Radio Equipment
The following (harmonised) standards and other
technical specifications were used as a basis:
ETSI EN 300 220-1 V3.1.1; ETSI EN 300 220-2 V3.1.1
Draft ETSI EN 301 489-1 V2.2.0;
Draft EN 301 489-3 V2.1.1; EN 62479:2010
ETSI EN 301 489-1 V2.1.1; ETSI EN 301 489-3 V2.1.1
The VCA, Bristol BS5 6XX, United Kingdom, has
granted the following type approval(s): E11 10R-05 10956
Signed for and on behalf of:
Truma Gerätetechnik GmbH & Co. KG
Alexander Wottrich
Managing Director

Technical data

Designation Mover smart M
Single-axis
Area of use
caravan with
overall weight of
up to 1800 kg
Max. climbing
ability
Operating
voltage
Maximum power
consumption
Average power
consumption
Quiescent
current
(Standby)
Maximum speed
Weight
Remote control
frequency
Subject to technical changes.
Putzbrunn, 11.11.2019
Mover smart A
Single-axis
caravan with
overall weight of
up to 2000 kg
13%
12 V
100 A 125 A
28 A 35 A
60 mA
(30 mA)
9 m/min
33 kg 32 kg
Class 1, 868 MHz
EN 17